Old Leafsprung Land Rovers

I've not got a decent photo, I'll post one tomorrow I think I've a piece of one piece seal still attached to the tub or side panel.

I'v just had a search for tube rivet tools and found this place.
http://www.aetools.co.uk/products-rivet-squeezers-squeezer-sets-accessories-for-an450-tubular-rivets-580.php

Not to far from home and not to pricey. Would work well in a G cramp type tool, should be able to squeeze in a controlled manner.

If they seal leave alone, if they leak try duct tape or butyl putty or a combination of both before replacing.

Cheers...

Managed to get most of them done with the Series seals, at least the rear SW tops had the holes in the right place... I took Calums advice and drilled some more holes as required, it isn't noticeable.  Of course I now can't shut the **** passenger door, this is because it was spot on, farmed out some work (due to over committing myself to projects) and it wasn't re-hung quite right.

Landies!!